Current position > Product detail
『Ruizhi air flow meter cleaning』Related information(v cone flow meter|rotary gas meter|gallon meter|gear meter|metal tube rotameter|glass tube rotameter|nutating disk meter|transit time ultrasonic flow meter|wedge flow meter|pd meters|hydraulic flow meter|ultrasonic water flow meter|water flow meter|air flow meter|magnetic water flow meter|oxygen flow meter|gas flow meter|argon flow meter|air velocity meter|gasoline flow meter|fuel flow meter|ultrasonic water meter|digital water meter|nitrogen flow meter|solid flow meter|Oxygen tank flow meter|digital water flow meter|diesel fuel flow meter|steam flow meter|02 flow meter|compressed air flow meter|oil flow meter|liquid flow meter)
1. How to clean the broken air flow meter of a diesel car?
The cleaning of the air flow meter (intake flow sensor) of a diesel car should follow the safety operation specifications. The core steps are power-off cooling, precise disassembly, gentle cleaning, and correct installation. The specific methods are as follows:
1. Preparation before cleaning.
Safety protection: Turn off the engine and wait for complete cooling (to avoid high temperature burns), disconnect the negative terminal of the vehicle battery (to prevent circuit short circuits)2. Positioning sensor: The air flow meter is usually located behind the air filter and near the intake manifold, and has the appearance of a metal tube with a sensor
3. Tool preparation: screwdriver/wrench (to remove fixed screws), soft brush/vacuum cleaner (to remove surface impurities), cotton swab, medical alcohol (to clean the sensor), clean and tidy cloth.
2. Cleaning steps 1 Dismantling process: Unplug the sensor plug (record the position for easy reset), remove the fixing screws, and carefully remove the flow meter from the sharp draft hole (avoid violent shaking)
2. External cleaning: Use a soft brush or vacuum cleaner to remove surface dust, dirt, and grease; External dirt can be gently wiped with soapy water and wiped dry (corrosive cleaning agents are prohibited)
3. Internal cleaning: focus on cleaning the sensor probe (precision components), gently wipe with a cotton swab dipped in a small amount of alcohol (do not press hard); The clogged filter can be cleaned with a toothbrush, and then thoroughly dried with cold air from a hair dryer (to avoid residual moisture).
III. Installation and Testing 1 Reset installat
_600x400.jpg)
2. Function test: Reconnect the battery, start the engine and idle for 5-10 minutes, and observe whether the fault light goes out; If it still lights up, use a diagnostic tool to clear the fault code or contact a professional repair.
IV. Precautions 1 Prohibited items: Silver dust. Do not use high-pressure water guns, highly corrosive cleaning agents (such as gasoline and acetone), and do not dry with hot air (which may damage the sensor).
2. Applicable scenarios: Only clean when the flow meter is dirty (such as P0101/P0102 fault code, weak acceleration). Regular maintenance of the vehicle does not require frequent operation.
3. Professional advice: If the fault still exists after cleaning, the flow meter should be replaced (precision components cannot be repaired after damage).
2. Pump suction air dust monitoring device cost
3.06 Ruizhi cleaned the throttle valve and air flow meter, but couldnt start the car?
After cleaning the throttle and air flow meter of the 06 Ruizhi, it cannot be started, possibly because the air flow meter was damaged during the cleaning process. The following are possible reasons and suggested solutions: Damaged air flow meter: Reason: The air flow meter is a precision sensor, and its internal structure and electronic components are relatively fragile. Improper operation during cleaning may cause damage. Solution process: Try unplugging the air flow meter and then try starting the vehicle. If the vehicle can start normally, it indicates that the air flow meter may have been damaged. At this point, a new air flow meter should